
                           UPDATING INFORMATION
                          ----------------------
   For Ver 3.01                                               14 Sept  1996

              If you are Updating from an earlier version of PROSKAN, it is
   advisable for you to go into the "CONFIGURE" screen and write down your
   old 'Crystal Clock Frequency' This is because as improvements were made,
   some slight Mode timings were changed and you may need the clock frequency
   setting . After you have completed the above, it will now be safe for you
   to  Overwrite the previous FSCAN.EXE with the Updated FSCAN.EXE.. Yes, you
   only have to overwrite FSCAN.EXE . If additional files are included on
   your update disk, add them to your PROSKAN files.

        When you run the new updated ver 3,0b for the first time, select (C)
   CONFIGURE, and the Configure screen will appear on the right side of the
   screen. Check that the (0) CRYSTAL CLOCK FREQUENCY is still the same, IF
   NOT, CORRECT IT. Then hit the Enter key to lock it in. After doing this,
   change to BASE TIMER MODE 2, which is the NORMAL running Mode. Check that
   the rest of the settings are correct and then (X) EXIT from the Configure
   screen. Now, on the left side select (S) to go to the SSTV screen. Now all
   of your pictures will come in as straight as you had them before. If not,
   you will have to tweek them in when receiving a strong SSTV picture signal.
   This should be only a very small amount. Just hope that the picture you
   are receiving is being transmitted straight.    Hi   Hi...
      Next go to the FAX setup and enter what Video Card you are using. Hit
   ENTER to lock it in.
                                  See you on SSTV,   Larry, N1FEH

